The Round Cordwood Studio

A round building of log ends set in mortar: thick, quiet, thermally massive walls that suit a pottery studio surprisingly well.

What is cordwood masonry?

Cordwood masonry builds walls from short, debarked log ends, typically 12–24 inches (30–60 cm) long, laid crosswise in mortar like stones. The wall thickness equals the log length.

Why round?

  • A circle encloses the most floor area for the least wall length.
  • Curved walls are naturally stable and resist wind well.
  • Round rooms suit a potter’s workflow: wheel, wedging table, shelves and kiln around the edge, with open space in the middle.

How the wall works

A common approach places two outer mortar beds, one inside and one outside, with an insulated cavity between them, often sawdust treated with lime. The mortar provides thermal mass; the cavity provides insulation; the wood conducts heat slowly along its grain.

Key practices

  • Dry, debarked wood of a species that shrinks little; cedar is popular. Wet wood shrinks and opens gaps.
  • Good overhangs and a raised foundation keep log ends dry: “a good hat and good boots.”
  • Mortar mix chosen for slow curing to limit shrinkage cracks.
  • Roof: round buildings often use a reciprocal-frame roof or radial rafters on a central post.

Permits and codes

Cordwood and other natural building methods are permitted in many places but not all. Talk to your building department early, especially about insulation values and fire safety near a kiln.

From the notebook