Wheel Throwing

Throwing is a physical skill. The steps are simple, but repetition is what makes them reliable.

1. Wedge the clay

Wedging (ram’s head or spiral) removes air pockets and evens out moisture. Air bubbles cause wobbles on the wheel and can burst in the kiln.

2. Center

With a wet, fast-spinning wheel, brace your elbows against your body and press the clay into a smooth, symmetrical mound. Coning up and down helps. If the clay runs true under a still hand, it is centered.

3. Open

Press your thumbs or fingers down the center, leaving about a centimeter (⅜ in) at the bottom, then widen the floor. Compress the floor to prevent S-cracks.

4. Pull the walls

Slow the wheel. With one hand inside and one outside, squeeze gently at the base and lift steadily to the rim. Three or four even pulls beat one heroic one.

5. Shape, compress the rim, cut off

Belly out from the inside, collar in from the outside, compress the rim with a chamois, then cut the pot free with a wire.

6. Trim at leather-hard

Re-center the pot upside down, secure it, and trim a foot ring so the wall thickness matches the base.

Troubleshooting

  • Wobble: not centered, or uneven pulls; slow down.
  • Collapse: too wet, too thin at the base, or too fast.
  • S-crack in the base: floor not compressed.
  • Torn rim: too much pressure at the top or the wheel too fast.

From the notebook